CCNA v3 Lab Guide: Routing and Switching

CCNA Lab Guide: Routing and Switching provides the lab skills necessary to pass the new CCNA exam. SIM labs and troubleshooting questions now account for at least 40% of all exam points. Learn how to configure, verify and troubleshoot all required CCNA labs. The packet tracer ready labs start from basic global configuration to more complex network troubleshooting of routers and switches.

There is coverage of IPv6 addressing and WAN protocols as well that are based on CCNA v3 exam guidelines. The troubleshooting questions are a key aspect of the CCNA exam. You will learn a standard troubleshooting methodology required for the CCNA v3 exam. The step-by-step format includes analysis and resolution of errors. The lab guide is based on the book CCNA v3 Routing and Switching 200-125.

• Cisco CCNA Lab Simulator
  
• Download Packet Tracer
  
• Configure, Verify and Troubleshoot Labs
  
• Initial Global Configuration, System Management
  
• Device Security, VLANs, Access Ports, Port Security
  
• Static Trunking, EtherChannel, Rapid STP, PortFast
  
• IPv4 Addressing, Subnetting, Static and Default Routes
  
• Multi-Area OSPF, EIGRP for IPv4, RIPv2, ACLs, NAT
  
• Inter-VLAN Routing, Default Gateway, DHCP, eBGP
  
• IPv6 Addressing, Link-Local, SLAAC, Global Unicast
  
• Network Troubleshooting, Traceroute, Ping, IOS Tools

Introduction
Packet Tracer Fundamentals

Part 1: Initial Device Configuration
Lab 1-1: Global Commands
Lab 1-2: System Management

Part 2: Switching Technologies
Lab 2-1: Device Security
Lab 2-2: VLANs
Lab 2-3: Access Ports
Lab 2-4: Switch Management
Lab 2-5: Port Security
Lab 2-6: Static Trunking
Lab 2-7: EtherChannel
Lab 2-8: Rapid STP (RSTP)
Lab 2-9: PortFast
Lab 2-10: Root Bridge Selection

Part 3: Routing Technologies
Lab 3-1: IP Addressing
Lab 3-2: Static Route
Lab 3-3: Default Route
Lab 3-4: Subnetting
Lab 3-5: Multi-Area OSPFv4
Lab 3-6: EIGRP for IPv4
Lab 3-7: RIPv2
Lab 3-8: Named ACL
Lab 3-9: Extended ACL
Lab 3-10: Port Address Translation
Lab 3-11: Router Management
Lab 3-12: Password Recovery
Lab 3-13: Inter-VLAN Routing
Lab 3-14: eBGP Peering

Part 4: IPv6 Addressing
Lab 4-1: Link-Local
Lab 4-2: SLAAC
Lab 4-3: Global Unicast

Part 5: Troubleshooting
Lab 5-1: Switch Interfaces
Lab 5-2: Trunking
Lab 5-3: Static Routing
Lab 5-4: EIGRP Neighbor Adjacency
Lab 5-5: EIGRP K Values
Lab 5-6: OSPF Timers
Lab 5-7: Access Control Lists (ACL)
Lab 5-8: Default Gateway
Lab 5-9: DHCP Server
Lab 5-10: PPP Authentication
Lab 5-11: Port Security
Lab 5-12: Router on a Stick
Lab 5-13: Remote Management
Lab 5-14: Traceroute
Lab 5-15: Routing and Switching